For the first fill pass, use a weave to ensure tie-in with the pipe wall. Grind the bead with a disc grinder to somewhat flatten the bead and expose the wagon tracks, as they can entrap slag. Installation - Century-Line Sleeves. Sales Manager - China. Pipetite Standard is ideal for new tubing installations where the boot can slide over the end of tubing before it is installed. Low-temperature properties are such that they may be installed under any weather conditions suitable for pouring concrete.
Ideal for cathodic protection systems, these non-conductive sleeves will neither rust, corrode or degrade. Pipetite Standard is ideal for new tubing installations where the boot can slide over the end of tubing before it is installed. Again, if it cannot be measured, it should not be rejected. This applies only when inside surface of the weld is readily accessible or the weld has been radiographed. Determination of Specific Gravity of Isocyanates. Soft copper can be specified where extreme forming is required, such as in complicated roof shapes.
Basic Welding Joints - Butt welded and Fillet welded joints -
Paper Standards and Packaging Standards. As an inspector tho I would want to examine the AFC dwgs for weld symbols, mill specs and general welding notes. Remember to measure threaded rod to match length of sleeve. Oxygen Enriched Atmospheres Standards. Silicone Boots are used for hot pipes, extreme environments and in corrosive applications. Show More Popular Products and Suppliers:. So, I guess one question that would be on my mind would be is there something that would be considered excessive penetration on a root pass as far as the depth in which the weld protrudes into the center of the pipe?
Restoration Coating Systems over Metal Roofs. Remember to measure threaded rod to match length of sleeve. One person working alone can usually install a Century-Line Sleeve regardless of the size. Fillet welded joints such as tee, lap and corner joints are the most common connection in welded fabrication. Aluminum is also damaged by wet mortar and wet plaster. Century-Line sleeves are light enough for one worker to install with-out a crane, hoist or helper which reduces installation time and costs. Search Close Search Bar.